Yes. A Minneapolis roof permit is required for re-roofing a house in the city. The City of Minneapolis says a building permit is needed for all re-roofing work, with an exception only for small repairs that use less than one bundle of shingles. The permit lets the city confirm the new roof meets the Minnesota Residential Code, including the ice barrier requirement at the eaves.
In most cases your roofing contractor pulls the permit, but owner-occupants can pull their own. Below we cover what work needs a reroofing permit in Minneapolis, who can apply, how fees are figured, what the code requires, and which inspections to expect. Rules and fees change, so always confirm the current details with the city before work starts.
In this article
- Do you need a permit to replace a roof in Minneapolis?
- What roofing work needs a building permit
- Who can pull a reroofing permit in Minneapolis
- How Minneapolis roof permit fees are calculated
- Building code requirements a reroof must meet
- The ice barrier requirement
- Inspections during and after a reroof
- How to apply for a Minneapolis roof permit
- Permits, contractors, and insurance claims
- What happens if you skip the permit
- Frequently Asked Questions
Do you need a permit to replace a roof in Minneapolis?
For a full roof replacement, the answer is yes. The city’s roofing handout for single-family and two-family homes states that a building permit is required for all re-roofing work. That covers tear-offs, overlays and re-shingling a whole roof or a whole roof section.
The handout’s one exception is a repair that uses less than one bundle of shingles, which it defines as 33 1/3 square feet. If you are replacing a handful of wind-blown shingles, that usually falls under the exception. Anything bigger should be treated as permitted work.
This requirement is not unique to Minneapolis. The Minnesota Department of Labor and Industry’s guidance on asphalt shingle roofing under the state residential code says building permits are required for re-roofing existing dwellings, and the state leaves fees and inspection details to each city.
One note on sources: the city’s roofing handout dates from 2016, though it references the 2020 Minnesota Residential Code. The core rules below have been stable, but treat the handout as a guide and check with Minneapolis Development Review for anything that matters to your project.
What roofing work needs a building permit
Here is how common roof projects line up with the city’s rules for one- and two-family homes:
| Project | Permit needed? | Notes |
|---|---|---|
| Full tear-off and new roof | Yes | Standard building permit for re-roofing. |
| Overlay (new shingles over one existing layer) | Yes | Allowed only in limited cases; see the code section below. |
| Small repair under one bundle (33 1/3 sq ft) | No, per the city handout | Must still follow the shingle manufacturer’s instructions. |
| Replacing roof sheathing | Covered by the reroof permit | A re-sheathing inspection can be requested but is not required. |
| Repairing rafters or trusses | Yes, an additional permit | Requires a framing inspection. |
| Dumpster or storage container on the street | Separate street use permit | The city issues 30-, 60- and 90-day permits for dumpsters and containers. |
The framing point catches people off guard. If a tear-off reveals rotted rafters or a damaged truss, structural repairs need their own permit and a framing inspection before they are covered up. A good contractor will stop and tell you when that happens.
If your home is a multi-unit building, a commercial property, or in an area with special design review, other rules can apply. Check with the city before you sign a contract.
Who can pull a reroofing permit in Minneapolis
Minneapolis allows two kinds of applicants for a residential building permit: owner-occupants doing their own work and contractors who hold the right license.
Homeowners doing their own work
According to the city’s permit applicant rules, individuals who own and live in a unit of a one- to four-unit dwelling can apply for a permit to do their own construction work. You must show a valid photo ID.
There are limits. Owners cannot pull permits for their own work if the property is held by a corporation, LLC or partnership. And if you build or improve more than one property within any 24-month period, the city requires a state Residential Building Contractor or Residential Remodeler license.
Pulling your own permit means you take responsibility for code compliance and for scheduling inspections. Roofing is also dangerous work, so think hard before doing a full replacement yourself.
Contractors
Contractors who apply for a Minneapolis building permit must show proof of a city residential specialty contractor license or one of these State of Minnesota licenses: Residential Building Contractor, Residential Remodeler, or Residential Roofer.
At the state level, the Minnesota Department of Labor and Industry says residential contractors who perform roofing work must hold a state license. Contractors whose annual gross receipts from residential contracting are under $15,000 can be exempt, but they must obtain a Certificate of Exemption every year. You can look up a contractor’s status with DLI’s online license lookup before you sign anything.
When a contractor pulls the permit, the permit is in their name and they are responsible for scheduling the final inspection. Ask for the permit number and make sure the permit card is posted or available at the job.
How Minneapolis roof permit fees are calculated
Minneapolis does not charge a flat roofing fee. Its building permit fee schedule and fee calculation worksheet base the fee on the construction value of the job. In plain terms, the more the job costs, the higher the permit fee.
The city’s worksheet breaks the total into three parts:
- Building permit fee: taken from a tiered table based on the job’s construction value, with a minimum fee.
- Plan review fee: normally 65 percent of the building permit fee, but the city says there is no plan review fee for simple permits such as roofing and siding.
- State surcharge: the construction value multiplied by 0.0005, which works out to 50 cents per $1,000 of job value. This surcharge is collected for the state.
The fee schedule we reviewed is dated 2019, and city fees are updated from time to time. We are not quoting dollar amounts for that reason. Your contractor will usually build the permit fee into the bid; if you are pulling it yourself, ask the city for the current schedule. For a broader look at what drives the total project price, see our roof replacement cost guide.
Building code requirements a reroof must meet
A building permit for a roof is really a promise that the work will meet the code. Minnesota uses a statewide code, so Minneapolis enforces the Minnesota Residential Code. The 2020 edition, based on the 2018 International Residential Code, took effect on March 31, 2020, and the state has been reviewing the 2024 IRC for a future update. Shingle manufacturer instructions also apply, and the city’s handout says the more restrictive requirement governs.
Key points from the city’s roofing handout and DLI’s shingle roofing guidance include:
Tear-off versus overlay
- One overlay is allowed over one existing layer if the existing roof is not water-soaked or deteriorated and the manufacturer’s method is followed.
- No overlays over existing wood shakes, slate, clay, cement or asbestos-cement tile.
- DLI’s guidance requires removing all existing coverings when there are already two or more layers.
Even where an overlay is legal, a tear-off lets the crew inspect the deck, fix soft spots and install a proper ice barrier directly on the sheathing. DLI’s guidance notes that tear-off generally gives a longer roof life.
Roof slope and underlayment
- Asphalt shingles need a minimum slope of 2:12 (2 inches of rise per 12 inches of run).
- Slopes from 2:12 up to 4:12 need two layers of underlayment, with 19-inch laps.
- Slopes of 4:12 and steeper need one layer, with 2-inch laps.
- End laps are offset at least 6 feet.
Deck, fasteners and flashing
- Shingles go on a solidly sheathed deck or on 1-inch nominal wood boards that meet the manufacturer’s limits.
- Nails must be corrosion-resistant, meet ASTM F1667, and penetrate the sheathing at least 3/4 inch or go all the way through thinner sheathing.
- The city requires at least four fasteners per strip shingle, or more if the manufacturer calls for it.
- Rusted, damaged or deteriorated flashing must be replaced, and the handout says roofing tar or asphalt cannot be used in place of approved flashing.
- A chimney wider than 30 inches parallel to the ridge that does not meet the ridge needs a cricket to divert water.
- Drip edge is required only if the shingle manufacturer requires it.
Ventilation
The city’s handout says existing homes do not have to add ventilation when re-roofing. That said, it also notes that ventilation helps reduce ice dams and shingle buckling, and many shingle manufacturers tie their warranties to proper attic ventilation. A reroof is the cheapest time to correct it.
The ice barrier requirement
Minnesota’s winters are why this rule exists. The city’s handout says Minnesota’s climate is treated as severe, so ice barrier protection is required on homes. The only exception it lists is detached accessory buildings with no conditioned floor area, such as many detached garages.
The ice barrier must run from the edge of the eave to a point at least 24 inches inside the exterior wall line of the building. On a house with deep overhangs, that means the membrane extends well up the roof, not just a single 3-foot strip at the edge.
Two types of ice barrier are allowed:
- A self-adhering polymer-modified bitumen sheet (often called ice and water shield), meeting ASTM D1970.
- At least two layers of underlayment cemented together.
The point of the ice barrier is to protect the deck when an ice dam forms and meltwater backs up under the shingles. It does not prevent ice dams; that takes air sealing and insulation in the attic. But it limits leaks when they happen, which matters in a city where ice dams are a routine winter problem.
Inspections during and after a reroof
Minneapolis keeps reroof inspections fairly simple. According to the city’s roofing handout:
- Underlayment and ice barrier: no inspection is required. Installers may take photos, but they do not have to submit them.
- Re-sheathing: an inspection may be requested but is not required, and it depends on inspector availability.
- Final inspection: required when the work is complete.
- Framing repairs: require a separate permit and a framing inspection.
Because the ice barrier is covered up before the final inspection, ask your contractor for dated photos of the ice barrier, underlayment and any new sheathing. Those photos are useful for your records, future insurance claims, and resale.
Questions about inspections go to the area building inspector named on the permit. Inspection procedures can change, so confirm what your inspector expects when the permit is issued.
How to apply for a Minneapolis roof permit
The general steps are the same whether you are a homeowner or a contractor:
- Confirm the scope. Decide whether the job is a tear-off or overlay, what material is going on, and whether any sheathing or framing work is likely.
- Apply through the city. Minneapolis Development Review handles construction permits. Homeowners and contractors can apply, and you can call 311 for help finding the right application.
- Show eligibility. Homeowners bring a photo ID and confirm they own and live in the property. Contractors show their license.
- Pay the fee. The fee is based on the job’s value plus the state surcharge.
- Arrange street use if needed. A dumpster or storage container on the street needs its own permit.
- Do the work and call for the final. Schedule the final inspection once the roof is complete.
Contractors who are pre-approved by the city can use an express permit tool for certain work on existing one- and two-family homes, and the city lists reroofs as eligible. That is one reason a contractor can often get a permit faster than a first-time homeowner applicant.
If you live in a suburb rather than the city of Minneapolis, your own city issues the permit. Requirements are similar under the statewide code, but fees and inspection steps vary, so check locally.
Permits, contractors, and insurance claims
After a hailstorm, permits become a useful filter. A contractor who will not pull a permit, or who asks you to pull one for work they are doing, is a red flag.
A few Minnesota rules are worth knowing when a roof is paid for with insurance money:
- Minnesota law bars residential contractors from offering to pay or rebate your insurance deductible.
- If you sign a roofing contract that depends on an insurance claim, state law gives you a right to cancel within 72 hours after your insurer notifies you that the claim is denied.
- DLI recommends checking a contractor’s license before you sign, and reading the full contract first.
Ask every bidder to state in writing who will pull the permit, whether the price includes the permit fee, and how they will document the ice barrier. If you are comparing options for a new roof, our roof replacement services page explains how the process typically runs from inspection to cleanup.
What happens if you skip the permit
Skipping the permit can look like a way to save time and money, but it shifts the risk to you as the owner:
- No independent check. Without a final inspection, no one outside the crew verifies the ice barrier, overlay rules or flashing.
- After-the-fact permits. The city can require a permit and inspection for work already done, and fees and fines are handled under the city’s fee rules.
- Resale questions. Buyers, appraisers and inspectors may ask about permit history for a new roof.
- Insurance friction. If a claim involves a roof that was not built to code, expect more questions from your insurer.
The permit is a small part of a roof’s cost and protects a large investment. If you are building new or adding a roof on an addition, our roof installation page covers what goes into a new system.
Frequently Asked Questions
Do I need a permit to replace my roof in Minneapolis?
Yes. The City of Minneapolis requires a building permit for re-roofing work. Its roofing handout exempts only small repairs that use less than one bundle of shingles, about 33 1/3 square feet.
Can a homeowner pull a reroofing permit in Minneapolis?
Yes, if you own and live in the property. The city lets owner-occupants of one- to four-unit dwellings apply for a permit to do their own construction work, and you will need a valid photo ID.
How much does a roofing permit cost in Minneapolis?
The fee is based on the construction value of the job, plus a small state surcharge. Roofing is treated as a simple permit with no plan review fee. Ask the city for the current fee schedule, because amounts change.
Is ice and water shield required on a Minneapolis roof?
Yes. Minnesota requires an ice barrier at the eaves, running from the roof edge to at least 24 inches inside the exterior wall line. It can be a self-adhering polymer-modified bitumen sheet or two layers of felt cemented together.
What inspections are required for a reroof in Minneapolis?
The city’s roofing handout lists a final inspection when the work is complete and says an underlayment or ice barrier inspection is not required. Framing repairs need their own permit and a framing inspection.
Can I put new shingles over my old roof in Minneapolis?
Sometimes. The city’s handout allows one overlay over one existing layer if the old roof is not water-soaked or deteriorated, but never over wood shakes, slate, clay, cement or asbestos-cement tile.
What happens if a roof is replaced without a permit?
Unpermitted work has not been checked against code, and the city can require a permit and inspection after the fact. Open or missing permits can also come up when you sell, so it is easier to get the permit up front.
The short version: plan on a building permit for any Minneapolis reroof beyond a small repair, make sure the ice barrier goes at least 24 inches inside the wall line, and confirm current fees and inspection steps with the city before you start.
Want a roof replacement quote that includes the permit? Call Minneapolis Roofing Company at (888) 657-0348 for a free estimate.

